PH Tool ASME Sec V Basic Calibration Block T-434.2.1

$1,049.00$2,929.00

Clear
Part # N/A Category

Used for establishment of primary reference responses for UT examination of welds. Block contains three side-drilled holes at 1.5″ deep minimum at 3/32″ diameter. Hole locations through the thickness are ¼, ½, and ¾T.

Diameter

1/2 ", 1-1/2 ", 3 ", 3/4"

Material

7075-T6 Aluminum, A516-70 Steel, Type 304 Stainless Steel

Version

Regular, Long Version

Case Included

None, Wood Case, Custom-Fitted Plastic Case

Used for establishment of primary reference responses for UT examination of welds.

Block contains three side-drilled holes at 1.5″ deep minimum at 3/32″ diameter. Hole locations through the thickness are ¼, ½, and ¾T. Also contains two EDM notches measuring 2%T deep x 1/4″ max wide x 1.0″ long min. In accordance with ASME Sec V Art. 4 Fig. T-434.2.1.

ASME Basic Calibration Blocks are intended to be representative of actual components, and therefore do not have the smooth scanning surfaces found on most general-purpose test blocks like the IIW or DSC. Instead, our Basic Calibration Blocks are media blasted on all surfaces to create a rough surface texture that is more characteristic of real-world inspection conditions.

  • Dimensions: ½” thick x 6¼” wide x 4.5″ long
  • Material: A516-70 Steel, bare
  • Fitted wooden storage case optional.

Special long version for 60/70° transducers or phased array.

The additional length allows for a full skip to the “top” notch. Used for establishment of primary reference responses for UT examination of welds. Block contains three side-drilled holes at 1.5″ deep minimum at 3/32″ diameter. Hole locations through the thickness are ¼, ½, and ¾T. Also contains two EDM notches measuring 2%T deep x 1/4″ max wide x 1.0″ long min. In accordance with ASME Sec V Art. 4 Fig. T-434.2.1.

ASME Basic Calibration Blocks are intended to be representative of actual components, and therefore do not have the smooth scanning surfaces found on most general-purpose test blocks like the IIW or DSC. Instead, our Basic Calibration Blocks are media blasted on all surfaces to create a rough surface texture that is more characteristic of real-world inspection conditions.

  • Dimensions: ½” thick x 6¼” wide x 6″ long
  • Material: A516-70 Steel, bare
  • Hardwood case optional
Login to NOMO

NOMO Deals

Get the best offers in NDT products.