Right Angle Weld Probe (90˚ tip, Transverse, Bridge)
| Designation | Tip Ø ‘D’, in/mm | Length, in/mm | Frequency, kHz | Connector | Material | Defects under paint coating | Subsurface defects |
| WLD100K5А.5×2-.2DAT0 | .2/5 | 2/50 | 100-1000 | Lemo 04 | Fe | up to 0.3 mm | + |
| WLD100K5А.5×2-.35DAT0 | .35/8.9 | 2/50 | 100-1000 | Fe | up to 1 mm | + | |
| WLD100K5А.5×2-.43DAT0 | .43/10.9 | 2/50 | 100-1000 | Fe | up to 1 mm | + | |
| WLD100K5А.5×2-.63DAT0 | .63/16 | 2/50 | 100-600 | Fe | up to 1 mm | + | |
| WLD100K5А.5×2.5-1DAT0 | 1/25.4 | 2.5/65 | 100-600 | Fe | up to 1.5 mm | + |
| WLD | 100K | 5А | .5 | × | 2 | – | .63D | AT | 0 |
| 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 |
- WLD – weld probe for welds testing.
- Probe frequency:
“HZ” designates the Hz range; “К” designates the kHz range; “М” designates the MHz range.
- Drop angle of sensing element.
- Drop length, inches.
- Probe length, inches. Can be changed upon request.
- Probe tip diameter, inches.
- Probe type designation “АT”. “А” – Absolute. “T” (Transverse) – designation of a transverse position of probe sensing element relative to the probe axis.
- Probe modification number.
Related products
-
OKOndt Straight Shaft Probe for sub-surface flaws detection
Only by Request Read more -
OKOndt Angle Shaft Surface Probe (45˚ tip, Single / Single Shielded)
Only by Request Read more -
OKOndt Dynamic Rotating Bolt Hole Probe
Only by Request Read more -
OKOndt Right Angle Surface Probe
Only by Request Read more
Designed by Minima Studio
